Sensor discovery, Figure 2.7, Enabling sensor discovery – RLE FDS-Wi V.2.5 User Manual
Page 19: Figure 2.8, Remove the sensors’s lid, Figure 2.9, Remove the battery’s protective tab
www.rletech.com
19
970.484.6510
2
Getting Started
2.5. Sensor
Discovery
The Wireless Gateway is equipped with a sensor discovery feature. The device will discover
available wireless sensor inputs and enter them into the Sensor Summary page. To configure
sensors to use with the Wireless Gateway, follow these steps:
1
In the Wireless Gateway’s user interface, go to the Configuration>FDS-Wi page. If it is not
already enabled, click the Enabled radio button for Sensor Discovery.
Figure 2.7 Enabling Sensor Discovery
2
Take off the sensor’s lid by pinching on the outer corners of the lid.
Figure 2.8 Remove the Sensors’s Lid
3
With the lid off, remove the polyester tab from the battery. Replace the lid.
Figure 2.9 Remove the Battery’s Protective Tab