HP DeskJet GT 5820 User Manual
Page 21
Cause
Solution
The printer receives a multi-page printing job, detects that the
paper length for the printing job does not match the length of
the loaded paper, and then prints out the first page of the job
with errors.
—
To cancel the printing job, press the Cancel button (
).
—
To continue printing the remaining pages, press the
Resume button (
). The remaining pages will have
the same errors as the first page.
TIP:
You can change the default paper size automatically
detected by the printer. For more information, see
default paper size detected by printer on page 21
.
●
The Number of copies icon is alternating between the letter E and the number 3. At the same time, the
Resume light is blinking, and the Power button light is on.
Cause
Solution
The carriage inside the printer has stalled.
Open the printhead access door and make sure the carriage is
not obstructed. Move the carriage to the right, close the
printhead access door, and then press the Resume button
(
) to continue printing. See
for more information.
CAUTION:
You must not open the printhead latch during this
process if printheads have been primed with ink. Opening the
latch can cause permanent damage to the printheads.
●
The Number of copies icon is alternating between the letter E and the number 4. At the same time, the
Error icon, the Paper Error icon, and the Resume light are blinking.
Cause
Solution
There is a paper jam.
Clear the jam, and then press the Resume button (
) to
continue printing.
For more information, see
.
ENWW
Control panel lights and display icons status
15