Create new project for rover, Shoot points, Collect points – NavCom SurveCE Integration Rev.A User Manual
Page 144
SurvCE™ Integration User Guide – Rev. A
B-142
Create New Project for Rover
1. Create a new project for the rover.
2. Connect to the rover. Define the coordinate
system. Initiate GPS raw data logging (see steps
in Use Local Coordinates from Appendix A,
section From Known Position Tab), then complete
the radio configuration. Tap
.
The receiver should be in RTK Fixed
mode.
3. Tap the Job menu to view the rover *.crd job (e.g.,
rover1.crd).
4. Tap GPS Rover to start the Bluetooth bonding, if
using Bluetooth.
5. Select Internal UHF radio.
6. Tap the RTK tab or
to start transmitting
corrections.
7. Format the SD card.
8. Select the rover *.crd file from the Files on the
Receiver window.
Shoot Points
1. Tap the Store Points menu.
2. Tap S from the Store Points table (see Figure 55).
3. Tap
. The data logging starts.
4. Tap Close the File to stop data logging.
Collect Points
The system is now ready to collect points.
- SF-3050 Logging Data to Internal Memory SurvCE (4 pages)
- SF-3040 Logging Data to Internal Memory or SD Card (6 pages)
- SF-3050 Logging Data to USB Using SurvCE (4 pages)
- StarFire over IP (5 pages)
- SF-3050 Quick Start (4 pages)
- SF-3050 A Computationally Efficient Ambiguity Resolution (7 pages)
- StarFire (5 pages)
- StarFire to SW v3.0.12.0 (3 pages)
- SF-3050 Rev.I (196 pages)
- StarUtil-3000 Rev.G (177 pages)
- Sapphire Rev.L (450 pages)
- StarUtil-3000 Rev.A (119 pages)
- SF-3050 Rev.A (169 pages)
- SF-3050 Rev.B (201 pages)
- SF-3050 Rev.D (235 pages)
- Rinex Utility Rev.D (17 pages)
- SF-3040 Quick Start (4 pages)
- SF-3040 Rev.F (217 pages)
- Install Utility Rev.C (26 pages)
- LAND-PAK Quick Start Rev.B (7 pages)
- LAND-PAK Rev.E (156 pages)
- StarUtil Rev.C (58 pages)
- LAND-PAK Rev.N (194 pages)
- StarUtil Rev.B (8 pages)
- StarUtil Rev.F (134 pages)
- SF-2040 Rev.E (63 pages)
- RT-3010 Rev.E (61 pages)
- StarFire Satellite Change Rev.G (24 pages)
- StarFire Satellite Change Rev.I (23 pages)
- TS Collecting Receiver (2 pages)
- TS Factory Default (2 pages)
- SF-2040 Rev.C (178 pages)
- LAND-PAK Rev.F (159 pages)
- SF-2040 Rev.F (93 pages)
- RT-3020 Rev.F (93 pages)
- SF-2110 Quick Start Rev.A (2 pages)
- StarPac Rev.A (15 pages)
- StarControl Rev.C (56 pages)
- SF-2050 Rev.F (99 pages)
- TruBlu Rev.A (2 pages)
- VueStar Rev.B (13 pages)
- SF-2110 Rev.B (99 pages)
- StarUtil-2110 Rev.A (85 pages)
- RT-3010 Rev.F (89 pages)