NavCom SurveCE Integration Rev.A - Manual (Page 110)

SurvCE™ Integration User Guide – Rev. A
3-108
coordinates, status (Fixed, Float, and
Autonomous) and HSDV and VSDV accuracy,
estimates are displayed at all times.
The remaining options on the Stake Points window
are described below:
• Add To List and Pick From List buttons: Create a
list of points to be staked. Tap the Add to List
button to add the current point in the Stake Points
window to the list. Tap the Pick from List button to
view the Stakeout Point List window and stake
any of the points on the list.

Source: After selecting a point or points
in the Stake Points window, SurvCE
displays the source of the point(s), either
as Current Job or Control File.

The display of the source is important
because the current job file and a control
file may contain the same point ID.
• Point by Direction: Check this option to stake a
point defined by a direction and distance, and
slope if applicable, from the current point
coordinate. This enables points to be staked
without calculating point numbers or point IDs for
the target point. Enter the bearing/azimuth,
horizontal distance and also slope, if applicable.

If the distance entry is not known but
must be computed, access the
calculator.