NavCom SurveCE Integration Rev.A - Manual (Page 126)

SurvCE™ Integration User Guide – Rev. A
4-124
 Exercise 5: Process GPS From RW5 File
This exercise provides steps to process GPS for
additional details, geodetic and grid coordinates,
geoid heights, rod heights, etc. from the *.rw5 file.

IMPORTANT : The output from Process
( Compute Points) > GPS contains the
grid coordinates and elevations on the
points. However, the latitude, longitude
and ellipsoid heights are at the L1 phase
center. The Rod Height is from the point
to the L1 phase center.
1. Transfer a *.rw5 file from the data collector to the
PC.
2. Run X-Port on the PC.
3. Select Process (Compute Points) > GPS. The
Process Options window opens.
4. Set the necessary parameters.
5. Click OK.
6. Print and/or save the results.
Menus & Commands
This section describes X-Port commands specific to
GPS.

Refer to the Carlson X-Port manual for
information on menus and commands
not described in this section.
Add Menu
Adding records to a *.rw5 file is most useful when
there are some additional conventional field traverse,