Measurement Computing DaqBoard 1000 Series - Manual (Page 72)

Secure the Grounding Pigtail to Cable CA-195CE
Using Cable Clamps 1033-2009, 1033-2010, and two 4_40 x 5/16 screws, secure the Grounding Pigtail to
the cable. Note that the Clamps must be positioned over the cable’s Copper Band as shown in the figure
on page 4-5. Tighten screws snug, but do not over tighten.
Note: In the following figure, the cable is not shown to allow for greater clarity of parts.
Connect Cable and Grounding Pigtail to DBK203
Note: DBK204 [for use with DaqBoard/2000 Series Boards] consists of a DBK203 and a CA-209 CE
cable kit. DBK204c [for use with cPCI DaqBoard/2000c Series Boards] consists of a DBK203 and
a CA-209c CE cable kit.
1.
Verify correct P4 connector alignment of the CA-195CE Cable and DBK203’s P4 connector.
2.
Complete the connection.
3.
Connect the open end of the Grounding Pigtail to the threaded insert located to the right of
DBK203’s P4 connector. See figure on page 4-5.
Note: When mating P4 connectors, ensure that the P4 white locator triangles
point to each other. The triangles locate pin A1.
At this point your board will be CE compliant, providing that the conditions listed on your board’s
Declaration of Conformity are satisfied. You can return power to the system and commence with normal
operation of your DaqBoard/2000 Series [or /2000c Series] Board.
4-6 CE-Compliance 959495 DaqBoard/1000 and /2000 Series User’s Manual