beautypg.com

Daqboard/2002, Daqboard/2002…… 1-15 – Measurement Computing DaqBoard 1000 Series User Manual

Page 37

background image

DaqBoard/2002

40 Digital

I/O

4 Counter

Inputs

2 Timer

Outputs

DaqBoard/2002 and /2002c are high-speed, multi-function, plug-and-play data acquisition boards for PCI
and compact-PCI bus computers, respectively. They feature digital calibration, bus mastering DMA,
40 digital I/O lines, four counters, and two timers.

Up to 470 channels of analog and digital I/O can be accessed with one board. Up to four boards can be
installed into a PC.

A 100-pin connector on the boards provides access to all of the input and output signals. The boards
accommodate all I/O with one cable and one PCI [or compact-PCI] slot. The 100-pin I/O connector, P4, is
logically divided into three ports:

P1 – Not used by DaqBoard/2002

P2 – General purpose digital I/O port with 24 lines, or digital I/O expansion port controlling up to

192 external lines.

P3 – 16-bit digital I/O port, counter inputs, timer outputs, and analog outputs.

The on-board scan sequencer lets you select up to 512 channel/range combinations. The sequencer scans
all channels of the scan at 5

µs/channel or 10 µs/channel.

Bus mastering allows digital/counter input data and digital output data to flow between the PC and the
DaqBoard/2002 board without consuming CPU time.

DaqBoard/2002 supports a complement of trigger modes including:

Digital and pattern triggering – The boards have separate digital trigger input line, allowing TTL-

level triggering and latencies less than 5

µs. The trigger can be programmed for logic level or edge

triggering. In pattern triggering, any of the digital input ports acts as the trigger port. You can program
the digital pattern.

Software-based triggering – The PC detects the trigger event from readings [digital, or counter].

Six pre- and post-triggering modes are supported.

Other features of the DaqBoard/2002 include:

40 TTL-level digital I/O lines. They are divided into three 8-bit ports and one 16-bit port.

Four 16-bit counters. Each can accept frequency inputs up to 10 MHz. The counters can be cascaded

into two 32-bit counters.

Two 16-bit timer outputs. Each can generate square waves from 16 Hz to 1 MHz.

Configuration through software. There are no switches or jumpers on a DaqBoard/2002.

DaqBoard/1000 and /2000 Series User’s Manual

889094

Daq Systems and Device Overviews 1-15

This manual is related to the following products: