Measurement Computing DaqBoard 1000 Series - Manual (Page 11)

DaqBoard/1000 and /2000 Series Installation
This guide tells how to complete the following steps for a successful installation.
Step 1 – Install Software …… page 2
Step 2 – Install Boards in Available PCI Bus-Slots …… page 3
Step 3 – Configure Boards ….. page 5
Step 4 – Test Hardware ….. page 6
Reference Note:
After you have completed the installation you should refer to the electronic documents that
were automatically installed onto your hard drive as a part of product support. The default
location is in the Programs group, which can be accessed from the Windows Desktop.
You should keep your DaqBoard’s serial number and your DaqView/2000 authorization code (if
applicable) with this document. Space is provided below for recording up to 4 board numbers and their
PCI bus-slot locations. The board serial number is located on the connector as indicated
in the following
figure.
Serial Number Location on DaqBoard/2000 Series Connector
The location is similar for DaqBoard/1000 Series Board.
Board Type (e.g.,
1000, 1005, 2000,
2001, etc.)*
Serial Number PCI Bus-Slot Location
Board 1
Board 2
Board 3
Board 4
The host PC can support up to four Boards.
*Note: DaqBoards have device labels which read, for example, “DaqBoard/1000,” “DaqBoard/2001,” “DaqBoard/2002,”
etc. The name labels are convenient for users of more than one board type.
DaqView/2000 Authorization Code ____________________________
Customers who ordered DaqView/2000 can find their authorization code on the authorization code sheet located inside the sleeve of the install CD.
Note that earlier documents may refer to this as a “registration code” or “registration ID.”
Customers who did not order DaqView/2000 can run a 30-day free trial version, as discussed elsewhere in the User’s Manual.
CAUTION
Take ESD precautions (packaging, proper handling, grounded wrist strap, etc.)
Use care to avoid touching board surfaces and onboard components. Only handle boards by their
edges (or ORBs, if applicable). Ensure boards do not come into contact with foreign elements such as
oils, water, and industrial particulate.
© 1999 through 2004 by 0HDVXUHPHQW&RPSXWLQJ&RUS 898195
1033-0940, rev . 8.0
IG
-1