Dbk205, Dbk206 – Measurement Computing DaqBoard 1000 Series User Manual
Page 54

DBK205
The DBK205 provides 12 screw-terminal connections on one terminal block (TB1) for DaqBoard/2003
and DaqBoard/2003c. The signal lines on DBK205’s P4 connector correspond with P3-associated pins on
the P4 connector of DaqBoard/2003 and /2003c. The DBK205 can connect directly to the 100-pin P4
connector on the DaqBoard/2003, or DaqBoard/2003c.
DBK205
Terminations
TB1-1 AGND
TB1-2 DAC0
TB1-3 AGND
TB1-4 DAC1
TB1-5 AGND
TB1-6 DAC2
TB1-7 AGND
TB1-8 DAC3
TB1-9 AGND
TB1-10 XTTL
TB1-11 CLK
TB1-12 DGND
DBK205 Adapter
DaqBoard/2003 Block Diagram
Note: DBK205 connects directly to
DaqBoard/2003’s or /2003c’s
P4 connector.
DBK206
The DBK206 provides a P1, P2, and P3 connector and corresponding screw-terminal blocks.
P1 is used for ANALOG I/O
•
•
•
P2 for DIGITAL I/O
P3 for Pulse/Frequency (Digital and Counter/Timer) I/O
DBK206, P4-to-P1/P2/P3 Adapter with Screw-Terminals
The DBK206 is suitable for both analog and digital expansion. Signal connection to a DaqBoard/2000
Series or to a DaqBoard/2000c Series board can be made as follows:
•
With cables connected to P1, P2, and P3 connectors, as applicable.
•
With signal wires connected to the appropriate screw-terminal blocks (TB1 through TB12).
Note that the DBK206 board’s silkscreen identifies all screw terminals.
•
With a combination of the above two methods.
Regardless of which method is used, the DBK206 connects to the 100-pin P4 connector of a
DaqBoard/2000 Series or a /2000c Series board. The connection is made via a CA-195 cable. The board
contains mounting holes that allow the board to be secured inside a user-provided enclosure.
Note: Board images are not to the same scale.
3-4 Connections & Pinouts, DaqBoard/2000 Series
898195
DaqBoard/1000 and /2000 User’s Manual