beautypg.com

Measurement Computing DaqBoard 1000 Series User Manual

Page 14

background image

7.

Refer to the figure at the right. Align the groove in the

DaqBoard’s PCI edge-connector with the ridge of the
desired PCI slot, and with the PC’s corresponding rear-
panel slot.

8.

Push the board firmly into the PCI slot. The board will

snap into position.

9.

Secure the board by inserting the rear-panel adapter-plate

screw.

10.

Using the previous steps, install additional boards into

available PCI bus-slots, if applicable to your application.

11.

Replace the computer’s cover.

12.

Plug in all cords and cables that were removed in step 1.

13.

Apply power to, and start up the PC.

Note: At this point some PCs may prompt you to insert an

installation disk. While this is rare, if you do receive such a
prompt simply place the install CD-ROM into the disk drive
and follow additional screen prompts.

Installing a DaqBoard/2000 Series Board

IG-

4 DaqBoard/1000 and /2000 Series Installation Guide

898195

1033-0940, rev 8.0

This manual is related to the following products: