Grandstream GVC3200 Administration Guide - Manual (Page 46)

Firmware Version 1.0.1.5 GVC3200 Administration Guide Page 45 of 61
Disable DND
Reminder Ring
It is used to set if the GVC3200 system will play the DND reminder ringtone for the
incoming call if the DND feature is enabled. If it set to “Yes”, the phone will keep
mute instead of playing a ring splash to indicate an incoming call when DND is
enabled.
The default setting is "No"
Disable Direct IP
Call
It is used to set if the GVC3200 system allows the end users to make an outbound
IP call. If it is set to “Yes”, the phone will hide the IP call feature and end users will
not be allowed to make an outbound IP call. The default setting is "No".
Use Quick IP-call
mode
It is used to set if the GVC3200 system will automatically fills in the first three octets
to make an outbound IP call. If it is set to "Yes", users can dial an IP address under
the same LAN/VPN segment by entering the last octet in the IP address. To dial
quick IP call, offhook the phone and dial #XXX (X is 0-9 and XXX <=255), the phone
will make direct IP call to aaa.bbb.ccc.XXX where aaa.bbb.ccc comes from the local
IP address REGARDLESS of subnet mask. #XX or #X are also valid so leading 0 is
not required (but OK). No SIP server is required to make quick IP call. The default
setting is "No".
Escape '#' as %23
in SIP URI
It is used to set what characters will be included in the SIP INVITE URI if end users
input #. If it is set to “Yes”, the GVC3200 system will replace the # by %23.
Otherwise, it will include # in the SIP INVITE message. The default setting is "Yes".
SETTINGS/GENERAL SETTINGS
Parameters Descriptions
Power Management
Enter Sleep Mode
(Min.)
Specifies the period before the device enters sleep mode if no operation is
performed.
If set "Never", the device will never enter sleep mode automatically. The default
value is "Never". If the device enters sleep mode, press POWER button on the
remote control to boot up.
When the device is in sleep mode, there is no display on the display device and web
UI access is not available.
Site Name Settings
Background
Transparency Set the display background transparency to be Opaque, 5%, 10%,15% and 20%.
The default setting is "Opaque".