Grandstream GVC3200 Administration Guide - Manual (Page 31)

Firmware Version 1.0.1.5 GVC3200 Administration Guide Page 30 of 61
• BlueJeans account. It’s always enabled
IPVideoTalk Pro account and BlueJeans account have part of the settings that the SIP account has. The
following table shows all the settings the SIP account has.
SETTINGS/SIP/GENERAL
Parameters Descriptions
Account Active
This field indicates whether the account is active. If disabled, the GVC3200 will not
send registration information to SIP server. The default setting is enabled.
Account Name
It is used to configure the name associated with each account to be displayed on the
upper left corner of LCD.
SIP Server
It is used to configure the URL or IP address, and port of the SIP server. This should
be provided by VoIP service providers (ITSP).
SIP User ID
It is used to configure the user account information, provided by your VoIP service
provider (ITSP). It's usually in the form of digits similar to phone number or actually a
phone number.
SIP Authentication
ID It is used to configure the SIP service subscriber's Authenticate ID used for
authentication. It can be identical to or different from the SIP User ID.
SIP Authentication
Password
It is used to configure the account password required for the GVC3200 to
authenticate with the ITSP (SIP) server before the account can be registered. After
saving, it will appear as hidden for security purpose.
Voice Mail UserID
This parameter allows you to access voice messages by entering voice mail or
dialing access number.
Display Name
It is used to configure the SIP server subscriber's name (optional) that will be used
for Caller ID display. The configured content will be included in the From, Contact
and P-Preferred-Identity headers of SIP INVITE message.
Tel URI
If the phone has an assigned PSTN telephone number, this field should be set to
"User=Phone". Then a "User=Phone" parameter will be attached to the Request-
Line and "TO" header in the SIP request to indicate the E.164 number. If set to
"Enable", "Tel:" will be used instead of "SIP:" in the SIP request. The default setting
is "Disable".
SETTINGS/SIP/NETWORK
Parameters Descriptions
Outbound Proxy
It is used to configure the IP address or the Domain name of the Primary Outbound
Proxy, Media Gateway, or Session Border Controller. It's used by the phone for
Firewall or NAT penetration in different network environments. If a symmetric NAT is
detected, STUN will not work and ONLY an Outbound Proxy can provide a solution.