Grandstream GVC3200 Administration Guide - Manual (Page 43)

Firmware Version 1.0.1.5 GVC3200 Administration Guide Page 42 of 61
SETTINGS/NETWORK SETTINGS
Network Settings lists Basic Settings, 802.1X, QoS, Proxy and Advanced Settings.
Parameters Descriptions
Basic Settings
Address Type
Allows users to configure the appropriate network settings on the device. Users
could select "DHCP", "Static IP" or "PPPoE". By default, it is set to "DHCP".
• DHCP: Obtain the IP address via one DHCP server in the LAN. ALL domain
values about static IP/PPPoE are unavailable.(Although some domain values
have been saved in the flash.)
• PPPoE: Configures PPPoE account/password. Obtain the IP address from the
PPPoE server via dialing.
• Static IP: Manually configures IP Address, Subnet Mask, Default Router's IP
Address, DNS Server 1 and DNS Server 2.
Host name
(Option 12) It is used to configure the name of the client in the DHCP request. It is optional but
may be required by some Internet Service Providers.
Vendor Class ID
(Option 60) It is used to configure the vendor class ID header in the DHCP request. The default
setting is “Grandstream GVC3200”.
DHCP Option 120
Override SIP
Server
Enables DHCP Option 120 from local server to override the SIP Server on the
device when DHCP is used. The default setting is "Yes".
IP Address It is used to configure the phone’s static IP address if the static IP is used.
Subnet Mask It is used to configure the network’s subnet mask if the static IP is used.
Default Router It is used to configure the network’s gateway address if the static IP is used.
DNS Server 1 It is used to configure the primary DNS IP address if the static IP is used.
DNS Server 2 It is used to configure the secondary DNS IP address if the static IP is used.
PPPoE Account It is used to configure the PPPoE account ID if the PPPoE is used.
PPPoE Password It is used to configure the PPPoE password if the PPPoE is used.
802.1x Mode