Gasboy CFN Series Gilbarco CRIND PC Interface for Site Controller III - Manual (Page 9)

MDE-4337G Gilbarco® CRIND® PC Interface for Site Controller III with Windows® · February 2011 Page 5
Gilbarco CRIND Keyboard Layout System Parameter Setup for PC-based Application using SC III
2 – Setup for PC-based Application using SC III
To use CRIND/ICR2 devices with the Site Controller, configure the READER.BIN menu 3
parameter as follows:
• Representative Pump Number - The pump number associated with each CRIND device.
• Auto Pump Select - Must be set to “Yes” for all CRIND devices and “No” for any Island
Card Reader (ICR) or ICR2, printer, or anything else that is not a Card Reader built into
the dispenser.
Note: Setting Auto to “Yes” for an ICR will cause unexpected deactivation of the
representative pump.
• Reader Type - Must be set to CRIND (type 7).
Gilbarco CRIND Keyboard Layout System Parameter
On page 4 of the SYS_PAR configuration, the Keypads parameter allows you to change the
default functions of the keys, if you have a Gilbarco CRIND or ICR2.
After selecting the Device type (1=CRIND, and so on), you will be prompted to enter the key
functions as a string of characters. The following table lists the characters and their respective
functions. The position of the character in the string corresponds to the position number of the
keys shown in the examples on the following pages.
Note: The characters are case-sensitive.
Character Function
0-9 Numeric Digits 0 to 9
. Decimal Point
E ENTER
C CLEAR
Y Yes
N No
X CANCEL
x CLEAR/CANCEL (CLEAR if Data Entry started; else CANCEL)
H Help
h Help/Decimal (Decimal if Data Entry started; else Help)
n No/CANCEL (No if in yes/no state; else CANCEL)
u Unused Key
d Debit Outside
b Credit Outside
The following functions are not used on an ICR2:
$ Cash Inside
c Cash Outside
D Debit Inside
B Credit (Bank Card) Inside
S Start