Gasboy CFN Series Gilbarco CRIND PC Interface for Site Controller III - Manual (Page 21)

MDE-4337G Gilbarco® CRIND® PC Interface for Site Controller III with Windows® · February 2011 Page 17
Parameters PC Applications
• To display softkeys, set the parameter to USE_SOFTKEYS=Y in the parameter file. If you
do not want the softkeys to be displayed, set the parameter to USE_SOFTKEYS=N in the
parameter file.
• To display the softkeys on the left side of CRIND, set the parameter to
ONLY_LEFT_SOFTKEYS=Y.
• For graphics mode using softkeys, to shift all prompting down by one line on the CRIND
display, set the parameter (requires interface version 2.1.3.0 or later) to
DISPLAY_OFFSET=20.
Note: For interface version 2.1.2.7 and earlier, messages can be displayed on the second
line down from the top by placing ~2 at the beginning of the message text. The ~2
will not be displayed. No space is required between ~2 and the text (for example,
~2One moment please…).
• Some CRIND devices may have a longer receipt chute, or changing the printer font can
make the receipt length shorter. If the receipt length must be adjusted, set the parameter to
MIN_RECEIPT_LENGTH=xx.
Where xx is equal to the total number of lines in the receipt. If the line is missing, the
CRIND device assumes a 24-line, which will provide a 3-inch receipt. There are
approximately eight lines per inch. For a 3-1/2 inch receipt, set xx to 28.
• The following setting limits the number of continuous beeps to x. This is useful for the
“pay inside” message that appears for 20 seconds after a transaction. Without setting this
parameter, there will be continuous beeps for 20 seconds. By setting this parameter, there
will be only x number of beeps: BEEP_LIMIT=x.
• In case you want a message to be displayed other than “Sale Cancelled” after a sale has
been cancelled, the text can be changed by setting the parameter to
SALE_CANCELLED_MESSAGE=Sale Cancelled.
• The Encore graphic CRIND displays appear in pairs, one on each side of the dispenser. It
is normal to have consecutive addresses with the lowest address being odd (for example,
1,2... 5,6...). If this is not true, you must list all the exceptions with CRIND_PAIR lines.
For example, you could have CRIND_PAIR=1,32 and CRIND_PAIR=2,31. Set the
parameter to CRIND_PAIR=x,y.