Parameters – Gasboy CFN Series Gilbarco CRIND PC Interface for Site Controller III User Manual
Page 20
PC Applications
Parameters
Page 16 MDE-4337G Gilbarco® CRIND® PC Interface for Site Controller III with Windows® · February 2011
Parameters
The CRIND.axx file contains the following parameters. These are sample settings and the
information after the equals sign (=) may vary between systems. An example is shown in
on
• FIRST_ADDRESS= and LAST_ADDRESS= refer to the CRIND address range that this
application is supposed to control.
ID=CRINDs1-16
FIRST_ADDRESS=1
LAST_ADDRESS=16
• The following setting determines if the CRIND device is to run in the debit mode for
Master Session or DUKPT with the GSM:
DEBIT_MODE=Y (for Master Session)
DEBIT_MODE=N (for no debit mode)
DEBIT_MODE=DUKPT (for DUKPT)
If the line is missing, the CRIND device assumes the non-debit mode
(DEBIT_MODE=N).
• If using an injected FlexPay EPP for debit, make the following settings:
DEBIT_MODE=DUKPT
Note: The injected FlexPay EPP can be used only with interface version 2.1.3.0 or later.
• The parameter file also allows you to set messages to be used for some pre-defined
conditions. The keyword phrase must be sufficient to describe the condition in which each
message is displayed.
READ_ERROR_MESSAGE=Please insert again
REMOVE_CARD_MESSAGE=Remove card quickly
PLEASE_WAIT_MESSAGE=One moment please...
OUT_OF_SERVICE_MESSAGE=Cannot process card
• Cash, Credit, and Debit prompts are displayed for softkey labels when the Press Payment
key is used. Payment softkeys placement can be controlled by setting the prompt label in
the parameter file (crind.ao1) and by including the softkey position in the text. For
example, “DEBIT_HERE_PROMPT=~1Debit Here” will put the “Debit Here” softkey in
the top left position (softkey 1).
CASH_HERE_PROMPT=Cash Here
CASH_INSIDE_PROMPT=Cash Inside
CREDIT_HERE_PROMPT=Credit Here
CREDIT_INSIDE_PROMPT=Credit Inside
DEBIT_HERE_PROMPT=Debit Here
DEBIT_INSIDE_PROMPT=Debit Inside
• The following setting determines whether the CRIND device must run in the graphics
mode or in the native mode with no graphics or softkeys. If the line is missing, the CRIND
device assumes the graphics mode (NATIVE_MODE=N).
NATIVE_MODE=Y
~ OR ~
NATIVE_MODE=N