Gasboy CFN Series Gilbarco CRIND PC Interface for Site Controller III - Manual (Page 19)

MDE-4337G Gilbarco® CRIND® PC Interface for Site Controller III with Windows® · February 2011 Page 15
PC Applications
6 – PC Applications
For the PC Application, all CRIND devices are controlled by the Gilbarco program, which
uses the CRIND.a0x parameter file that is located in C:\SC3\XBIN\ (see
Figure 6-1 ).
Figure 6-1: Example of CRIND.a0x Parameter File
Note: This example is for illustration purposes only. Your file will differ depending on
site-specific requirements. The CRIND.a0x file must contain only what is required to
operate, but you can comment out lines by placing an asterisk (*) at the beginning of
each line that must be ignored by the system.
These XBIN files must all have unique file extensions. For example, if the site has one
Gilbarco pump with a Gilpump.a01 parameter file, one Gilbarco CRIND device with a
CRIND.a02 parameter file, and a Unitec Car Wash, the Car Wash parameter file cannot be
named WASH.a01 or WASH.a02; it must be named WASH.a03.
The CRIND program reads only this file when it starts. Therefore, you must restart the
program using ALT-R, whenever a change is made. You must perform the same for broadcast
messages and receipt headings loaded in the site.
ID=CRIND1-16
FIRST_ADDRESS=1
LAST_ADDRESS=16
NATIVE_MODE=N
DEBIT_MODE=Y
ITEM=Qt oil:99:42
ITEM=Other:0:42
ITEM=Beer:129:42
ITEM=Junk:999:42
READ_ERROR_MESSAGE= Please insert again
REMOVE_CARD_MESSAGE= Remove card quickly
CASH_INSIDE_PROMPT=CASH INSIDE
CREDIT_INSIDE_PROMPT=CREDIT INSIDE
DEBIT_INSIDE_PROMPT=DEBIT INSIDE
PLEASE_WAIT_MESSAGE=One moment please
WASH_TYPE_PROMPT=Select car wash type
WASH_TYPE=reg
WASH_TYPE=super
WASH_TYPE=deluxe