Gasboy CFN Islander II - Manual (Page 20)

System Layout
03/07/03 2-9
CUSTOMER DISPLAY (OPTIONAL)
Install the customer display as follows:
1.
Remove the protective tape holding the connecting cable to the tube.
2.
Thread the connecting cable from the tube down through the tube fitting in the base, under
the base and up through the opening in the base plate (Figure A). Be careful not to drop
display.
3.
Install the tube in the tube fitting, position the display, and tighten the set screw in the tube
fitting.
4.
Take the strain relief bushing and, using pliers, squeeze the bushing onto the wire. Snap the
bushing into the retaining plate (Figure B).
5.
Screw the retaining plate to the base as shown in Figure A.