Gasboy Dial 001 - Manual (Page 27)

20 Gasboy Dial 001 Credit & Debit Card Networks
Gasboy CFN Series 03/07/03
Bad Fleet data format request
Bad fleet completion format request
Contact your GASBOY representative should you ever see this message.
Adjust Tables, Router Table min=xxxx
Run TABLES and allow for the specified number of bytes for the Router Table.
Fleet Format Disabled
System is not programmed for fleet applications. run GASDIAL -E and enable the “Fleet
Format” field.
Unknown Card Type (not available)
If a debit card is used, the Debit key must be pressed. Otherwise, the card is not
programmed to be accepted.
Special console operations
Special credit card keys for manual entry
With some cards you will need to set up a special key on the console for handling the manual
entry of credit cards. The manual-entry process is identical to the standard method of using the
key (which is described in the Check Point and Profit Point manuals). Once you make
the assignment with the directions below, the key should be labeled to indicate its new use.
Check Point consoles
Submenu 1 of the CONSOLE configuration program (explained in the Site Controller II
Configuration Manual ) is used to assign a card type to a Check Point key. Assign action 85 to a
key to manually accept the cards on that key.
Profit Point consoles
On the Profit Point, special function 68 calls up the network-card-selection menu. You can
deactivate the networks you don’t want by commenting out the appropriate line in the
CONFIG.POS file with an asterisk in the first column.
If your CONFIG.POS file has a line that reads NETWORK TEXACO CARD=95, either change
TEXACO to PHILLIPS, or comment out that line and add one that reads NETWORK xxxxxx
CARD=95.
The transaction pointer
If you are not regularly polling and resetting the transaction pointer, then you should run the
PURGE SITE command once a day so you do not fill up the Site Controller’s memory.
CREDIT