Gasboy Dial 001 - Manual (Page 14)

Credit & Debit Card Networks Gasboy Dial 001 7
03/07/03 Gasboy CFN Series
The Card Number on ICR Receipt option allows four values:
‘A’ - All digits printed.
‘4’ - Last four digits only.
‘S’ - Suppress first four digits and last (check) digit. This is for use by domestic PH&H
cards.
‘N’ - None, no digit shown.
If the account number will be printed on the customer receipt when the purchase is done at an
island card reader (check with your bank to see if they allow this), then set the value to ‘A’ for all
digits to be printed. VISA and MasterCard restrict bank card account numbers printed on the
Island receipt to the last four digits of the account number. You can set this restriction by
entering a ‘2’ at this prompt.
The Fuel Override Price Level field is used to set a special price level for a card: 1 is cash, 2 is
credit. The normal stand-in level is 0 (the stand-in limit is also referred to as the fallback level).
A special pricing level can be used for each card.
If instant-on is allowed for a card type, set the Instant On field to Yes (N/A).
The Okay Flags field will display:
‘E’ if Expiration Date is enabled.
‘F’ if the card is accepted in Fallback mode.
‘R’ if Returns will be allowed.
‘U’ if unattended authorization is allowed. (You must run the command
GASDIAL -g0 to activate.)
‘V’ if Voice Authorizations will be allowed.
Pay at the pump
Setting the Island Preauth amount field to $1.00 for bank cards will cause the site to only
dispense $50 in fuel. You may override this $50 limit but you must get approval from your
network representative.
The host also returns an available-to-buy amount for fleet cards. This allows the host to maintain
the maximum authorized amount for all terminals of a specific company.
Program New Cards for Acceptance (-O)
Gasboy Dial has the flexibility to have new cards added without a new version of the network
software. The information for the card must be requested from your Network Representative and
the Network must know you will be accepting the new card.
This menu allows the user to configure the Gasboy Dial software to accept a previously
unknown card. This table must only be set up with the assistance of your Network
Representative. Only 3 entries are available. Should these “Programmed” cards need to be made
permanent, contact your Gasboy Sales Representative with a hard copy of the table for reference.
You will need your Network Representative to provide the following information before
you can begin to edit the table:
• ISO account range (may also be referred to as the ABA Number)
• Track II account length as read from the stripe. This is the number of digits in the mag-
netically recorded account number before the expiration date, but not including the
usual field separator found before the expiration date.
• Is merchandise accepted?