Gasboy 9800Q Series - Manual (Page 33)

CAUTION CAUTION
This line must not be shorted to any conduit or chassis metal, mis-wired, used to
control both stages of a satellite valve, or be connected to equipment requiring
more than 170mA from this line to operate, or the CPU PC board will be
instantly damaged.
MDE-4340A Series 9800Q Pumps and Dispensers Installation/Operation Manual · January 2006 Page 4-5
Control Lines
This line must be left capped when not in use. Follow the checks in “Pump/Remote Dispenser
Operation” on page 6-1 before applying power to avoid accidental damage.
Phase 2 Feed
The Phase 2 feed is a hot feed that is the opposite phase of the pump motor feed. This line
and the pump motor feed are used for 230 VAC domestic motor applications. If connected to
equipment requiring control of the authorization input, the Phase 2 Feed should be switched
through a separate relay to prevent false triggering of the authorization signal.
Slow/Fast Satellite Returns
These lines are used only in units that come equipped with satellite piping. They are used in
applications where the remote dispenser and satellite may not dispense product at the same
time. These lines are not connected internally as they leave the factory. Four lines are provided
for twins.
CAUTION CAUTION
These lines must not be shorted to any conduit or chassis metal, or be connected to
equipment requiring more than 170mA from each line to operate, or the CPU PC
board will be instantly damaged.
These lines must be left capped when not in use. Follow the checks in “Pump/Remote
Dispenser Operation” on page 6-1 before applying power to avoid accidental damage.
Light Feed
The Light Feed is a 115 VAC input required to power the fluorescent lights. In a site
configuration that use multiple remote dispensers (or pumps), the power for the lights of up to
eight units can be supplied by one breaker. It is recommended that this be on a separate
breaker from the Micro/Heater Feed to reduce electrical noise and allow for separate control of
the lights.
Light Neutral
The Light Neutral is a return line for AC current from the lights to the breaker panel. When
a separate breaker is not used to control the lights, the light neutral is attached to the Micro
Neutral.