Formax 6304 Series - Manual (Page 45)

43
ENGLIS
H
6. OPERATOR MAINTENANCE
Warning
• Disconnect the mains power supply before performing any maintenance.
The user must not attempt to service the appliance beyond that described in
this operator manual. All other servicing must be carried out by qualified
service personnel only.
Please contact your authorized distributor.
Maintenance
frequency Maintenance
Daily • Check the system functions.
• Keep the system in proper condition by removing dust,
paper remains, etc.
• When dirty, clean the sealing table and rubber rollers with a slightly
wetted cloth, soaked in warm water.
Weekly • When dirty or saturated, clean the brushes of the envelope sealing.
The system is delivered with an extra set of brushes. To always have
one clean set available, it is recommended to soak one set in water
and use the other set.
Remove the brushes one by one by pulling them down from the
brush holder.
Replace the brushes and make sure that the studs on the brushes
are fitted in the corresponding holes in the brush holder.
• Check moistening cloth and replace if necessary.
When dirty or saturated, clean the moistening cloth and the
reservoir.
• Clean feed and insert rollers as instructed by the service engineer.
When
necessary • When the touch screen warns about dusty sensors, the sensors on
the envelope or document path must be cleaned. Use the bellows
that is located behind the side cover.
Place the bellows in the hole and firmly squeeze a few times to blow
the dust from the sensor. Repeat this procedure for the hole to clean
the flap sensor.
If the exit sensors have to be cleaned, use a slightly wetted cotton
swab:
-
Lower exit sensor: insert the wetted cotton swab into the hole
and spin once.
- Upper exit sensor: insert the wetted cotton swab into the hole
for the upper sensor and spin once.
Note
When finished cleaning the sensors always calibrate the sensors
(see 2.4.6 ”Test Menu” on page 11).