Formax 6304 Series - Manual (Page 43)

41
ENGLIS
H
3. Loosen the stack of documents and place them in the feeder.
BREs with flap down and leading (top side pointing to system).
The feeding plate assembly will be shifted up automatically (when the system starts
processing) until documents/BREs are underneath the rubber paper pullers.
Note
When filling the Production Feeder, be sure that the document/BREs are positioned parallel
in relation to the feed plate to ensure correct feeding.
5.5 High Capacity Feeder
This option can only be installed from factory. The High Capacity Feeder has a capacity for
up to 725 sheets. The normal document feeder tray has a capacity of 325 sheets.
5.5.1 Installation of Feeder Tray
To install the feeder tray of the High Capacity
Feeder:
1. Pull down lever A.
2. Hook in the feeder tray.
3. Release lever A.
5.5.2 Adjusting the Side Guides
To adjust the side guides B:
1. Loosen the knob D half a turn.
2. Put a small stack of documents between the side
guides.
3. Rotate wheel E.
The space between the side guides and the documents should be such that the
documents have just enough play to move freely.
4. Re-tighten knob D.
5.5.3 Document Separation
The document separation is set automatically. There are no manual adjustments needed.
5.5.4 Filling the High Capacity Feeder
To fill the document feeder tray:
1. Pull down lever A.
The feeder rollers C move up to filling level.
2. Place a stack of documents between the side guides (max. 725 sheets, 80 g/m²).
Feed the documents (depending on the type of documents and the type of fold) as
shown in 3.4.1 ”Document Orientation” on page 14.
3. Release lever A.
A B C D E