Formax 6304 Series - Manual (Page 42)

40
5.4.3 Adjust Side Guides
Adjust the side guides:
1. Take a stack of documents/B REs and place them
in the feeder tray.
BREs with flap down and leading (top side
pointing to system).
2. Adjust the side guides by turning the thumb
wheel G so the documents/BREs just fit and can
move without resistance.
Too much play causes skewing.
5.4.4 Document Separation
When the Production Feeder is used as an automatic
separation feeder, the separation is set
automatically.
The Production Feeder can also be used on a feeder
position with a manually adjusted separation.
To adjust, proceed as follows:
1. Remove feeders 2 and 3.
Note
The lowest feeder is feeder 1.
2. Squeeze the two blue handles C and D and shift
the feeding plate F as far as possible to the front.
3. Push knob E forward until it clicks.
4. Place a document/BRE on the feeder tray and slide it in the system till the leading
edge is not visible anymore. Turn knob E counterclockwise if the separation is set too
narrow.
5. Push the document/BRE between the rollers.
6. Turn knob
E clockwise to get more resistance and counterclockwise if the separation is
set too narrow.
The separation is adjusted correctly when a slight resistance is felt on the document/
BRE.
7. Pull knob E back when ready.
8. Remount feeders 2 and 3.
5.4.5 Feeding Documents
To feed documents:
1. Squeeze the two blue handles C and D.
2. Shift the feeding plate F to the rear position.
G H I J
C D F
E