Formax 6304 Series - Manual (Page 23)

21
ENGLIS
H
4.2 Job Settings
From the “job settings” menu the following settings
are available:
If you want to view the job details of the current job, press the button. If you want to
run a test set or test envelope, you can use the green buttons in this menu.
4.2.1 Envelope Settings
In the ‘envelope settings’ menu you can define the
envelope properties and switch the sealing on and
off.
In the top of the screen, three selection buttons are
displayed, from which one can be selected. The
selected settings button will be highlighted.
• Press to select an envelope with closed
flap. This means that the envelopes are fed with
closed flap. Use the upper button to enter
the applicable dimensions.
It is also possible to select ISO standard envelopes or dimensions in inches (depends
on the installation settings).
The envelope height can be set between 90 mm (3.5 inch) and 162 mm (6.38 inch).
Envelope settings (see 4.2.1 ”Envelope
Settings," below)
Document settings (see 4.2.2 ”Document
Settings” on page 22)
Fold settings (see 4.2.3 ”Fold Settings” on
page 24)
Reading settings (if installed) (see
4.2.4 ”Reading Settings (Option)” on page
25)
Double feed control settings (see
4.2.5 ”Double Feed Control Settings” on
page 26)
Job name settings (see 4.2.6 ”Job Name” on
page 26)
Mailing/Franking settings (if installed) (see
4.2.7 ”Mailing/Franking Settings (Option)”
on page 27)
Mail Piece Production Control (MPPC)
settings (if installed)
See the appendix operator manual Mail
Piece Production Control