4 maxifeeder™ (mf-2), 1 function, 2 preparations – Formax 6304 Series User Manual
Page 41: High capacity vertical stacker (hcvs-1), Englis h

39
ENGLIS
H
•
Dial tone detection on / off
This setting is required if no dial tone is heard during establishing a connection. The
default value is on. This setting is relevant to some PABX telephone switch systems.
Press
to switch the dial tone detection on or off.
•
Volume of modem: set the modem volume.
a
Press
to change the volume of the speaker.
Do not set the volume to zero as the sound of the modem is helpful during
remote assistance.
Press
OK
to confirm modified settings.
5.4 Production Feeder (MF-2)
5.4.1
Function
The Production Feeder is a feeder that can be loaded with a high number of documents.
This feeder is intended to be used for Business Reply Envelopes (BRE), but also ‘standard’
documents up to 156 mm (6.1") length can be processed with it.
5.4.2
Preparations
The Production Feeder should be installed at the
position of feeder no. 1.
It can be placed into position in the same way as the
other document feeders.
Proceed as follows:
1. Lift the paper feed rollers with the front edge of
the Production Feeder.
2. Move the Production Feeder forward until it hooks
behind the frame axle.
3. Connect the connector A to the socket B.
The Production Feeder is auto-detected by the system
when the system is switched on. This makes it easy
to switch over from the standard document feeder tray to the Production Feeder and vice
versa.
Note
To allow easier hooking on of the Production Feeder it is advised to put the feeding plate in the
rear position (see 5.4.4 ”Document Separation” on page 40).
To use the Production Feeder it is not necessary to (re-)program the jobs.
A
B