Limitorque actuation systems – Flowserve DDC-100 Master Station II User Manual

Page 2

DDC-100 Master Station II Installation and Operation Manual

FCD LMAIM5001-00

Flow Control Division

Limitorque Actuation Systems

Master Station

Installation and Operation Manual

Printed in the United States of America.

Disclaimer

No part of this book shall be reproduced, stored in a retrieval system, or transmitted by any means,

electronic, mechanical, photocopying, recording, or otherwise without the written permission from

Flowserve. While every precaution has been taken in the preparation of the book, the publisher assumes

no responsibility for errors or omissions. Neither is any liability assumed for damages resulting from the

use of the information contained herein.

This document is proprietary information of Flowserve furnished for customer use ONLY. No other uses

are authorized without written permission of Flowserve.

Flowserve reserves the right to make changes, without notice, to this document and the products it

describes. Flowserve shall not be liable for technical or editorial errors or omissions made herein; nor for

incidental or consequential damages resulting from the furnishing, performance or use of this document.

This manual contains information that is correct to the best of Flowserve’s knowledge. It is intended to be

a guide and should not be considered as a sole source of technical instruction, replacing good technical

judgment, since all possible situations cannot be anticipated. If there is any doubt as to exact installation,

configuration, and/or use, please contact Flowserve at 1-800-225-6989.

The choice of system components is the responsibility of the buyer, and how they are used cannot be the

liability of Flowserve Corporation. However, Flowserve’s sales team and application engineers are always

available to assist you in making your decision.

MS-DOS

is a registered trademark of Microsoft Corporation.

IBM-PC

is a registered trademark of International Business Machines Corporation.

Belden

is a registered trademark of Belden, a division of Cooper Industries, Inc.