Flowserve Logix MD+ ValveSight - Manual (Page 87)

ValveSight™ Diagnostics DTM Manual for Logix MD+ Positioner with HART®
FCD- LGENSF0014-00
© Flowserve Corporation
87
Set Pilot Relay Travel Limits
The Current Value is the total pilot relay travel recorded by the positioner. The Initial
Warning is the point at which the Pilot Relay Travel Warning will begin. The Full Warning is
where the health bar on the Dashboard will show fully yellow. The Full Warning value is
the only limit that can be modified. The Initial Warning is always 90% of the Full Warning
value. The reset button will set the Current Value to zero. The Training Travel Rate field
displays average amount of travel per day of the bellows during the training period. For
more information about Training, see the
Health - Training page.
Training Status
Training Status is present on this page because one or more fields or graphs shows data
that was gathered during the training process. The field shows one of the following states:
•
Training Enabled - which indicates system data is being recorded. Training should
run during normal system behavior.
•
Training Disabled - which indicates NO system data is being recorded.
•
Training Complete which indicates that the time period for training has expired and
the data is stored in the positioner.
NOTE: The Training function requires the Pro positioner upgrade level (522MD+).
Action Buttons
The Apply button will save changes to the connected device.
The Retrieve button will retrieve the latest information from the device.