Flowserve Logix MD+ ValveSight - Manual (Page 52)

ValveSight™ Diagnostics DTM Manual for Logix MD+ Positioner with HART®
FCD- LGENSF0014-00
© Flowserve Corporation
52
the Abort button.
Pressure Calibration in Progress
•
Definition: A pressure calibration sequence is in progress.
•
Possible Solutions: The calibration can be canceled from the Sensor
Calibration page of the DTM, from the handheld, or by briefly pressing
the Abort button.
Friction Calibration in Progress
•
Definition: A friction and diagnostic calibration sequence is in
progress.
•
Possible Solutions: The calibration can be canceled from the Sensor
Calibration page of the DTM, from the handheld, or by briefly pressing
the Abort button.
Command In Calibration in Progress
•
Definition: The command input calibration sequence is in progress.
•
Possible Solutions: The calibration can be canceled from the Sensor
Calibration page of the DTM, from the handheld, or by briefly pressing
the Abort button
A/O Calibration in Progress
•
Definition: The analog output calibration sequence is in progress.
•
Possible Solutions: The calibration can be canceled from the Sensor
Calibration page of the DTM, from the handheld, or by briefly pressing
the Abort button
Jog Calibration in Progress
•
Definition: During a jog calibration, the unit is waiting for the user to
manually adjust the valve position to the desired 100% open position.
•
Possible Solutions: Use the Up and Down buttons on the positioner to
adjust the valve to the desired fully open position. The QUICK-
CAL/ACCEPT button to accept.
Electronic Configuration Status
Aux. Card 1 Present
•
Definition: An auxiliary card is present in slot 1.
•
Possible Solutions: Two cards may be installed. See manual for more
details.
Aux. Card 2 Present
•
Definition: An auxiliary card is present in slot 2.
•
Possible Solutions: Two cards may be installed. See manual for more
details.
Pressure Board Present
•
Definition: Pressure sensors are physically present in the positioner.