Epiphan VGADVI Recorder - Manual (Page 16)

Table 4 VGADVI Recorder Back Panel Descriptions
Label Name Description
Audio Out Connect to audio equipment, such as headphones or speakers, to confirm
the audio stream is captured.
DVI Out Connect to video equipment, such as a monitor or projector to confirm the
video stream is captured.
Connect one of the following sources:
DVI output, use the DVI to DVI cable (included)
VGA output, use the VGA to DVI cable (included)
Note: This connection can convert a VGA input signal to DVI output signal.
To confirm the video stream from an s-Video port, refer to Configure
channels .
USB Connect to one of the following devices:
l
big red button for recording control
l
external HDD
l
USB flash drive
l
mouse to start and stop recording
l
RS-232 serial port for remote control
Note: Using more than one USB device may impact system performance.
RJ-45 Attach the provided RJ-45 cable and connect to a powered Ethernet port.
The port is auto-sensing and supports negotiations at 10/100 speeds.
Power over Ethernet is used to power VGADVI Recorder. If the network
connection does not provide power, use the provided power over Ethernet
injector to power the device.