Epiphan VGADVI Recorder - Manual (Page 133)

VGADVI Recorder User Guide 5-3 File and Recording Transfer
2. Specify the target Server address. If your device is configured with DHCP or has a valid DNS
configuration (see Configure Network Settings ), you can use the server’s fully qualified domain name
instead of the IP address.
3. Specify the Server module. This is the name of the shared folder on the server. If needed, request this
value from your network administrator.
4. Specify a username for the RSync Server in the Login field. The user must have write permissions for the
module.
5. Specify the password for the user in the Password field; the value is masked by dots.
6. If desired, select the Checksum check box to add a checksum validation to the transfer between the
device and the recipient server.
7. Click Apply; if there are any problems the system notifies you with a message: One or more parameter
values are not valid and those were not applied!
The following table describes the options applicable to configuring upload to an RSync server.
Table 23 RSync Automatic File Upload Configuration Options
Name Description / Options
Server address The IP address (or fully qualified domain name) of the RSync server.
Server module The name of the shared folder on the RSync server.
Login Username for the RSync server.
Password Password for the RSync user.
Checksum Select to enable checksum checking during file transfer. This increases the time taken to
transfer, but also increases reliability of the transfer.
124