Epiphan VGADVI Recorder - Manual (Page 134)

VGADVI Recorder User Guide 5-3 File and Recording Transfer
Configure Automatic File Upload using CIFS (Part 2 of 2)
This procedure assumes you have completed the steps in Configure Automatic File Upload (Part 1 of 2) and
wish to continue with configuration of upload using CIFS (also known as SMB or samba).
To configure upload using CIFS:
1. Select CIFS Client from the protocol drop down list in the Automatic File Upload configuration page; the
lower half of the page reflects the selection.
2. Specify the target Server address. If your device is configured with DHCP or has a valid DNS
configuration (see Configure Network Settings ), you can use the server’s fully qualified domain name
instead of the IP address.
3. Enter the target Server port, if you have configured the server to use something non-standard. Leave
this value blank to use the default port.
4. Specify the Server share. This is the CIFS share name or the name of the shared folder on the server. If
needed, request this value from the network administrator.
5. If the device is in a different domain than the server or if it is part of Active Directory, enter the Domain
name of the CIFS server.
6. Specify a username for the CIFS Server in the Login field. The user must have write permissions for the
share folder.
7. Specify the password for the user in the Password field; the value is masked by dots.
8. Select Use temp file file to name files with a temporary filename extension (.part) on the server until
upload is complete.
9. Click Apply; if there are any problems the system notifies you with a message: One or more parameter
values are not valid and those were not applied!
The following table describes the options applicable to configuring upload to a CIFS server.
125