Epiphan VGADVI Recorder - Manual (Page 132)

VGADVI Recorder User Guide 5-3 File and Recording Transfer
instead of the IP address.
3. Specify the Server Port used for the target FTP server. The standard port is 21.
4. Enter the FTP account username in the Login field.
5. Enter the FTP account password in the Password field; the characters are masked with dots.
6. Select Use temp file to name files with a temporary filename extension (.part) on the server until upload
is complete.
7. Click Apply; if there are any problems the system notifies you with a message: One or more parameter
values are not valid and those were not applied!
The following table describes the options applicable to configuring upload to an FTP server.
Table 22 FTP Automatic Upload Configuration Options
Name Description / Options
Server address The IP address (or fully qualified domain name) of the FTP server.
Server port The port used by the target FTP server. Standard port is 21.
Login Username for the FTP server.
Password Password for the FTP user.
Use temp file Causes files to be named with .part extension on the server during active upload. When the
upload completes, the file is renamed to the appropriate extension (.mov or .avi).
Configure Automatic File Upload using RSync (Part 2 of 2)
This procedure assumes you have completed the steps in Configure Automatic File Upload (Part 1 of 2) and
wish to continue with configuration of upload using RSync.
To configure upload using RSync:
1. Select RSync Client from the protocol drop down list in the Automatic File Upload configuration page;
the lower half of the page reflects the selection.
123