Daktronics AF-3700-34 RGB - Manual (Page 20)

Power Installation 14
For 8-pixel high displays only:
Terminating hot, neutral, and ground wires at the J-box
1. Route the power cable through 3/4” conduit to the rear of the display and into the power
termination J-box.
2. The power termination enclosure will contain two or three wires plus a ground coming
from the interior of the display. These wires are pre-terminated to the power termination
panel inside the display.
3. Inside the external power termination J-box, connect the power wires to the wires coming
from the display interior using wire nuts. Refer to Figure 20 and Figure 21for a diagram.
Note the following colors are used for the pre-terminated wires:
120 VAC
240 VAC
• Line 1 – Black x Line 1 - Brown
• Neutral - White x Line 2 - Red
• Grounding – Green-Yellow x Neutral - Blue
x Grounding – Green-Yellow
Figure 20: 120 VAC Power Termination
Figure 21: 120/240 VAC Power Termination