Comtech EF Data LBC-4000 - Manual (Page 89)

LBC-4000 L-Band Up/Down Converter System Revision 4
Serial-based Remote Product Management MN/LBC4000.IOM
6–17
Parameter
Type
Command
(Instruction Code
and
Qualifier)
Arguments for
Command or
Response to Query
Description of Arguments
(Note that all arguments are ASCII numeric codes between
48 and 57)
Response to Command
(Target to controller)
Query
(Instruction Code
and qualifier)
Response to query
(Target to controller)
Set Auto/Manual
Redundancy Mode SAM_ 1 byte
alphanumeric
Command and Query.
Used to set or get status of Redundancy to either Manual or
Automatic mode in the form SAM_x where:
x = a (if chassis is in Automatic Redundancy mode) or
m (if chassis is in Manual Redundancy mode)
Same as command SAM_ SAM_
(see Description of
Arguments for details)
Summary Alarm
Status N/A 2 bytes,
alpha
Query only.
Used to Query the status of the Summary Fault Relay in the
form SAS_xx where:
xx = OK or FT
Example: SAS_OK
N/A SAS_
SAS_x
(see Description of
Arguments for details)
Remote Baud Rate SBR_ 4 bytes Command or Query.
Used to set or query the serial baud rate in the form SBR_xxxx
where:
xxxx = remote baud rate as follows:
1200 = 1200 baud
2400 = 2400 baud
4800 = 4800 baud
9600 = 9600 baud
19K2 = 19200 baud
38K4 = 38400 baud
Same as command SBR_
SBR_xxxx
(see Description of
Arguments for details)
Remote Address SPA_ 4 bytes,
numeric
Command or Query.
Used to set or query the physical address in the form SPA_xxxx
where:
xxxx = Set Physical Address-between 0001 to 9999.
Resolution=0001
Example: SPA_0412
Same as command SPA_
SPA_xxxx
(see Description of
Arguments for details)
Spectrum Inversion SPI_ 5 bytes Command or Query.
Used to set or query the Converter spectrum inversion setting,
in the form SPI_x_yyy where:
x = ‘A’ (Converter A) or ‘B’ (Converter B)
yyy = NRM (normal spectrum) or INV (inverted spectrum).
Example: SPI_A_INV (Converter A set to inverted spectrum)
Note: This command is only valid for down converters.
Same as command SPI_x_ SPI_x_
(see Description of
Arguments for details)