Comtech EF Data LBC-4000 - Manual (Page 80)

LBC-4000 L-Band Up/Down Converter System Revision 4
Serial-based Remote Product Management MN/LBC4000.IOM
6–8
6.3 Remote Commands and Queries
The table that follows provides a ‘quick reference‘ to the Instruction Codes available at present for M&C of the LBC‐4000. The ‘C’ and ‘Q’
columns, when marked with an ‘X’, denote whether that Instruction Code is Command Only, Query Only, or Command and Query.
Instr Code C Q Page Instr Code C Q Page Instr Code C Q Page
AID X X 7-9 IMG X X 7-13 SAM X X 7-17
ATO X X 7-9 SAS X 7-17
ATT X X 7-9 SBR X X 7-17
LAA X 7-13 SPA X X 7-17
SPI X X 7-17
CAA X 7-9 SRO X X 7-18
CAS X 7-10 MUT X X 7-13 SSA X X 7-18
CCS X 7-10 SSN X 7-18
CMM X X 7-11
CMS X 7-11 ONL X 7-13 TIM X X 7-18
CUS X 7-12
RAS X 7-14 VFD X X 7-18
DAT X X 7-12 RCS X 7-15
RED X X 7-15
REM X X 7-15
FBU X 7-12 RET X 7-15
FRE X X 7-12 RET_x X 7-16
FRL X X 7-12 RMS X 7-16
FRW X 7-13 RUS X 7-16
NOTE – Instruction Code Qualifiers, as defined in Sect. 6.2.2.5, are used as follows in the command/query tables’ ‘Response to Command’
columns:
= Message OK * Message OK, but not permitted in current mode
? Received OK, but invalid arguments found # Message OK, but unit is not in Remote mode
! Invalid instruction