Comtech EF Data LPOD-R User Manual
Lpod-r
Table of contents
Document Outline
- MN-LPODR REV 1
- Errata A, Updates to Section 2.3
- Errata B, Added Appendix C
- Table of Contents
- PREFACE
- Chapter 1. INTRODUCTION
- Chapter 2. SYSTEM CONNECTIONS, INSTALLATION and STARTUP
- 2.1 Overview
- 2.2 Interface Connectors
- 2.2.1 Connector J1 | LBAND IN
- 2.2.2 Connector J2 | RF OUT
- 2.2.3 Connector J3 | POWER IN AC Power Mains
- 2.2.4 Connector J3 | POWER IN Optional DC Power Mains
- 2.2.5 Connector J6 | COM1 (Remote Communications and Discrete Control Port – PS 1, PS 1.5 ONLY)
- 2.2.6 Connector J6 | COM1 (Ethernet Communications Port – PS .5 ONLY)
- 2.2.7 Ground Connector
- 2.3 Single Thread (Standalone) LPOD-R Installation
- 2.4 Set the LPOD-R Power On
- Chapter 3. UPDATING FIRMWARE
- 3.1 Introduction
- 3.2 Prepare for the Firmware Download
- 3.2.1 Required User-supplied Items
- 3.2.2 Configure the Terminal Emulator Program, if necessary
- 3.2.3 Find the LPOD-R firmware and version numbers
- 3.2.4 Make a temporary folder (subdirectory) on the User PC
- 3.2.5 Use the Windows Desktop to make a temporary folder
- 3.2.6 Use Windows Explorer to make a temporary folder
- 3.2.7 Use the Run and Browse windows to make a temporary folder
- 3.2.8 Use Windows Command line to make a temporary folder
- 3.3 Download and Extract the Firmware Update Files
- 3.4 FTP Upload the Firmware Files and Update the LPOD-R Unit
- 3.5 Recover the User Interface Access
- Chapter 4. ETHERNET-BASED REMOTE PRODUCT MANAGEMENT
- Chapter 5. OPTIONAL SERIAL-BASED REMOTE PRODUCT MANAGEMENT
- Appendix A: CABLES
- Appendix B. MAINTENANCE