Comtech EF Data LPOD-R - Manual (Page 118)

LPOD-R Outdoor Amplifier / Block Up Converter (BUC) MN-LPODR
Optional Serial-based Remote Product Management Revision 1
5–8
5.4 Remote Commands and Queries
Column C = Command; Column Q = Query; columns marked X designate instruction code as Command only, Query only, or
Command/Query.
Where an Instruction Code is noted in this table as XXX E (and where the Parameter Type column is in the format E ), this
denotes the command/query as End of Life (EOL). See Sect. 5.2.1 for more information.
CODE C Q PAGE CODE C Q PAGE CODE C Q PAGE CODE C Q PAGE Note: The following codes are used in the ‘Response to
Command’ column: AFR X X 5–9 FAR X X 5–13 MAC X 5–17 SFA X X 5–23
ATT X X 5–9 FRW X 5–14 MSK X X 5–17 SNO X X 5–23 CODE MEANING
MUT X X 5–17 SSI X X 5–23 = Message OK
SWR
X 5–23 ? Received OK, but invalid arguments found
* Message OK, but not permitted in Current mode
CAA E X 5–9 GAC X X 5–14
CAE X 5–9 NUE X 5–18
# Message OK, but only permitted in Remote mode
CAS X 5–10 NUS X 5–18 TIM X X 5–24
CCS X 5–11 TMP X 5–24 ! Unknown command
CID X X 5–11 TSC X X 5–24
CMS
X 5–12
IEP X 5–14
CUS E X 5–12 IPA X X 5–15
IPG X X 5–15 PNM X 5–18
ISP X 5–15
DAT E X X 5–12 RAS
X
5–18
DAY X X 5–13 RBT X 5–19
LNA E X 5–15 RCS
X
5–19
LPT X X 5–16 RET E
X
5–20
LRS X X 5–16 RMS X 5–20
RNE X 5–21
ESA X X 5–13 RNS X 5–22
RSN E X 5–23
RUS X 5–23