Comtech EF Data LPOD-R - Manual (Page 94)

LPOD-R Outdoor Amplifier / Block Up Converter MN-LPODR
Ethernet-based Remote Product Management Revision 1
4–8
Use the command IPA=xxx.xxx.xxx.xxx.yy, where: xxx.xxx.xxx.xxx is a valid IP address on the
network where the unit is to be installed, and yy is the range (typically, yy = 24).
Changing the IPA value requires that you cycle power on the unit, and then start a new
Telnet session using the new IP address.
See Chapter 5 for more information on the LRS and IPA commands.
4.4.2 User Login
1. From the PC, enter the default IP address for the LPOD-R (e.g., http://192.168.1.4) into the
Address area of the browser.
2. In the Login window, type the User name and Password, and then click OK. The default User
Name and Password are both comtech.
Once the valid User Name and Password is accepted, the LPOD-R Web Server Interface
splash page shows. The Firmware Version in this example is subject to change.