Comtech EF Data LPOD-R - Manual (Page 103)

LPOD-R Outdoor Amplifier / Block Up Converter MN-LPODR
Ethernet-based Remote Product Management Revision 1
4–17
4.4.7 Status Pages
Use these pages to see the unit’s operational status, logged alarm and statistics windows.
4.4.7.1 Status | Summary
This read-only page shows a summary of information about the LPOD-R unit and its current
operating state. Refresh the page to see the latest data.
Figure 4-6. Status | Summary Page
Summary (read only)
The Summary Fault message shows OK on a green background if no faults are present. If a fault
exists, the message changes to FAULT on a red background. Should this occur, look at the logged
faults and alarms on the Status | Events page.
Terminal Status Change
If Terminal Status Change shows NO, there have been no changes in the unit’s configuration
since the last time the Terminal Status Change status was cleared.
If Terminal Status Change shows YES, a status change had occured for one or more of these
reasons:
• An operating parameter changed, (e.g., when a command changes an operational value)
• A fault condition occurs
• A redundant switchover occurs
To reset the Terminal Status Change from YES to NO, click Clear.