Comtech EF Data MBT-4000 - Manual (Page 67)

MBT-4000 Multi-Band Transceiver System Revision 4
Remote Control MN/MBT4000.IOM
A–23
Parameter
Type
Command
(Instruction
Code and
qualifier)
Valid on
MBT,
BDC, or
BUC
Arguments
for Command
or Response
to Query
Description of Arguments
(Note that all arguments are ASCII numeric codes – i.e.,
ASCII codes between 48 and 57)
Response to
Command
(Target to
Controller)
Query
(Instruction
Code and
qualifier)
Response to
Query
(Target to
Controller)
Terminal
Status change N/A All 1 byte,
value of 0,1
Query only.
Used to Query the status of the Terminal Status.
Where:
0=no change in status
1=change in status
Example: TSC=0 N/A TSC? TSC=x
(see description
for details of
arguments)
External
Reference
Fault Logic XRF=x MBT 1 byte,
value of 0,1
Command or Query.
XRF controls whether or not the Software monitors the external
reference source. If enabled and no source is present, a fault will
be reported.
Where:
0=Ext Reference not monitored
1=Ext Reference is monitored and the lock state reported
Example: XRF=1 XRF=(message OK)
XRF?(received OK,
but invalid arguments
found) XRF? XRF=x
(see description
for details of
arguments)