Comtech EF Data MBT-4000 - Manual (Page 62)

MBT-4000 Multi-Band Transceiver System Revision 4
Remote Control MN/MBT4000.IOM
A–18
Parameter
Type
Command
(Instruction
Code and
qualifier)
Valid on
MBT,
BDC, or
BUC
Arguments
for Command
or Response
to Query
Description of Arguments
(Note that all arguments are ASCII numeric codes – i.e.,
ASCII codes between 48 and 57)
Response to
Command
(Target to
Controller)
Query
(Instruction
Code and
qualifier)
Response to
Query
(Target to
Controller)
Retrieve
Configuration
Status N/A All 65 bytes
(MBT-4000)
98 bytes
(BDC),
76 bytes
(BUC)
alphanumeric
Query only.
Used to Query the configuration status of the unit
Example for MBT-4000 base:
<0001/RCS?{cr}
>0001/RCS={cr}
BF1=X {cr}
BF2=X {cr}
BT1=DN{cr}
BT2=UP{cr}
RED=0{cr}
RAM=00{cr}
MBT=N, A, or B
EXT=0{cr}{lf}
Example for BDC or BUC:
<0001A1/RCS?{cr}
>0001A1/RCS={cr}
FLO=06300{cr}
ATT=01.00{cr}
MUT=1{cr}
SLP=0.3{cr}
LCS=0{cr}
LCW=99{cr}
LFL=1{cr}
REF=XXXX{cr} (reserved for future use)
XRE=X{cr} (reserved for future use)
AFR=0{cr}{lf}
Note: For BUC, LCS, LCW, & LFL will not be shown.
N/A RCS? RCS=x….x
(see description
for details of
arguments)
Redundancy
State RED=x MBT 1 byte,
value of 0,1,
or 2
Command or Query.
Controls redundancy state, where:
0=Off
1=Enables redundancy using single base unit
2=Enables redundancy using dual base units
Example: RED=1
RED= (message OK)
RED? (received OK,
but invalid arguments
found)
RED* (message OK,
but not permitted in
current mode) RED? RED=x
(same format as
command
arguments)