Comtech EF Data MBT-4000 - Manual (Page 54)

MBT-4000 Multi-Band Transceiver System Revision 4
Remote Control MN/MBT4000.IOM
A–10
Parameter
Type
Command
(Instruction
Code and
qualifier)
Valid on
MBT,
BDC, or
BUC
Arguments
for Command
or Response
to Query
Description of Arguments
(Note that all arguments are ASCII numeric codes – i.e.,
ASCII codes between 48 and 57)
Response to
Command
(Target to
Controller)
Query
(Instruction
Code and
qualifier)
Response to
Query
(Target to
Controller)
Calibrate LNA
Current CLC= BDC none Command only.
This command is used to set the calibration point for the LNA
current alarm feature.
Example: CLC=
CLC=(message ok)
CLC?(received ok,
but invalid arguments
found)
CLC*(message ok,
but not permitted in
current mode)
CLC!(command not
accepted by BDC
sub-units.) N/A N/A
Calibrate LNA
Current CLC=s MBT S=1 byte
Value of
1 , 2
1=LNA A
2= LNA 2 Command only.
This command is used to set the calibration point for the LNA
current alarm feature, where s = Source:
1=LNA A (AUX COMM1)
2=LNA B(AUX COMM2)
Example: CLC=1 CLC=(message ok)
CLC?(received ok,
but invalid arguments
found)
CLC*(message ok,
but not permitted in
current mode)
CLC!(command not
accepted by BUC or
BDC sub-units.) N/A N/A