Comtech EF Data MBT-4000 - Manual (Page 42)

MBT-4000 Multi-Band Transceiver System Revision 4
Flash Upgrading MN/MBT4000.IOM
5–4
3
Double-click FLSHCSAT.EXE
(filename or icon) to execute
the flash upload utility.
4
From the FLSHCSAT
window, select the pertinent
serial port used for
communication between the
user-provided PC and the
MBT-4000.
(In this example, as noted at
‘A’, COM1 has been
selected.)
5
Do not select a Baud Rate
(noted at ‘B’) other than the
default selection of 38400,
unless otherwise instructed
by Comtech EF Data
Technical Support.
6 Click on ‘Software Upload’,
as noted at ‘C’.
7
The user is prompted to
select the firmware file to
upload. Click ‘Choose File’,
then select the file from the
temporary folder created
earlier by using the box to the
right to navigate to the
desired folder, then double-
clicking on the firmware file
using the box to the left.
8
Prior to continuing the upload
process, the MBT-4000
system must be powered off.
Disconnect the power cable
from the Base Unit, then click
on ‘Start Upload’ to resume
the upload process.
A
B
C