Comtech EF Data MBT-4000 - Manual (Page 41)

MBT-4000 Multi-Band Transceiver System Revision 4
Flash Upgrading MN/MBT4000.IOM
5–3
4. Extract the files to the temporary folder on the PC, then verify the success of the file extraction
and transfer via the dir command. At least four files should be extracted:
• ReleaseNotes_vX-X-X.pdf, where “X-X-X”
denotes the firmware version.
• FW11811x.CCC, where "x" denotes the firmware
revision letter.
• FLSHCSAT.EXE: CEFD Flash Upload Utility
Program.
• CCCflash.hlp: FLSHCSAT Help File.
If these four files as identified are displayed, proceed to the next section to perform the flash
upgrade.
5.3 Flash Upgrade Procedure
Step Procedure
1
Locate and Identify the
MBT-4000 Multi-Band
Transceiver System.
The illustration to the right
serves to identify key
features of a typical
system.
2
Ensure that the MBT-4000
system is connected to a
user-provided, Windows-
based PC.
Note: If needed, the
CA/WR12243-1 System
Programming Cable is
available from Comtech
EF Data. Contact CEFD
Customer Support for
ordering information.