BECKHOFF ET1100 - Manual (Page 50)

Appendix
46 Slave Controller – Application Note FAQ
8. Enter “Start Offset” of 300, activate “Auto Reload” and “Compact view”. Press the “Reload” button
to see the error counters from 0x0300 ff. The error counters are again shown as 16 bit values.
Figure 21: Error counters in the Advanced Settings window
9. To clear an error counter, write any value into it, it is the write accesss and not the value which
clears the error counter. Refer to the ESC data sheet section II to find out which error counters
are cleared in a group.
Figure 22: Write any value into an error counter to clear it.