Avery Dennison SS Finisher - Manual (Page 35)

Users Manual SS Finisher Appendix C •••• 35
Appendix C
Label / Machine Speed
The SS Finisher is capable of producing labels from 25mm to 259mm in length.
Not all AVERY DENNISON printers will slow down sufficiently to produce the
minimum feed so the SS Finisher will not fall behind creating a loop of material
between the two products. AVERY DENNISON 6500 and 642 printers will run
at the slower speeds labeled as “False”. AVERY DENNISON 636, 656, 676
and SNAP printers will slow down to 3” per second minimum feed rate. Use the
chart below to make the proper format speed selection for the desired printer
636 and 656 printer speeds: 3”/sec, 4.5”/sec, 6”/sec and 7”/sec.
676 and 676LKP printer speeds: 3”/sec, 4”/sec and 5”/sec.
SNAP printer speeds: 3”/sec, 4.5”/sec, 6”/sec and 7”/sec.
Note: If running a SS Finishing Station with a LOKPRINT System – DO NOT
run above 5” per second. The label will not be finished properly and
may not hold up in the application.
Print Speed Minimum Length
3 IPS 1” (25 mm)
4 IPS 1.6” (40 mm)
4.5 IPS 1.7” (42mm)
5 IPS 2” (52mm)
6 IPS 2.3” (58mm)
7 IPS 2.8” (70mm)