Avery Dennison SS Finisher - Manual (Page 27)

Users Manual SS Finisher Trouble Shooting •••• 27
Instrument Panel
Single Screen Input
COUNTER 999999 STOPPED
LEN:XXXmm CUT: SPD:
Overview
The display has only three operator-input fields displayed at all times. The left
two gray keys at the bottom of the display control the cut length in millimeters.
The next two buttons adjust the cut position and the last button is speed. The
speed selection has little impact on machine throughput.
Feed Length
To enter the proper label feed length - measure the label desired to be cut from
one registration mark to the exact same place on the next registration mark as
illustrated below. The feed length should be set to 76mm.
COPY AREA COPY AR
FEED
20 10 40 30 70 60 50 90 80 140 110 100 130 120
The feed length may have a value from 25mm to 129mm. Use the arrow keys to
increase or decrease the displayed value. The value will change in single
millimeter increments by holding the button or single button pulses. The value
that is displayed will be the new length - no save or enter key is required.