Avery Dennison SS Finisher - Manual (Page 28)

Users Manual SS Finisher Trouble Shooting •••• 28
Position the label registration mark so that the green light beam from the sensor
is just to the right of the registration mark. The light should be in a blank area of
the label in the feed direction. This should be done manually.
Cut Position
When the desired feed length has been selected, start the printer and run labels
into the stacker. After two or three labels have fallen into the stacker - stop the
printer and remove the top label. Measure the distance from the end of the label
to the desired cut location. Add or subtract the value from the value displayed.
DO NOT input the value, it must be added to or subtracted from the current
value. The maximum value is ± the label length from zero. The cut value
cannot be greater than the label length. The cut number for the label illustrated
below should be decreased by 19mm to cut in the center of the registration mark.
COPY AREA
FEED
10 20 30 40 50 60 70 80
Use the arrow keys to increase or decrease the displayed value. The value
will change in single millimeter increment by holding the button or single button
pulses. The value that is displayed will be the new length, no save key is
required.