Avery Dennison SS Finisher - Manual (Page 16)

Users Manual SS Finisher Operation •••• 16
Squaring the Horn to the Blade
ROTATE
To square the Horn to the Blade, first loosen the four square adjusting cap
screws, shown above. This will allow the stack to rotate. Next loosen the two
adjusting cap screws shown below. Once they are loose, place a 3/16 ball driver
next to the deck and slide entire stack against the ball driver. This will square
the horn to the deck. Next, tighten the four square adjusting screws. Once they
are tight, return stack to the center of the blade by turning the screw adjustment,
and then tighten the two adjusting cap screws.